Call to reach a local rooferHillsboro, OR 97123
Call (833) 751-2102
(833) 751-2102
Serving Washington County

Gutter and Downspout Repair in Hillsboro, OR

Restoring gutters, downspouts and outlets in Hillsboro and nearby towns, cleared of moss and leaves so roof water is carried clear of the walls.

Call (833) 751-2102Free estimate
  • Roof repair and full replacement
  • Moss, wet-season leaks and wind damage
  • Pitched roofs across Washington County

Get a fast quote

Fastest: call (833) 751-2102. Or send this and we call you back.

By sending this form you agree that Hillsboro Roofing may call or text you at the number provided about this request. Consent is not a condition of purchase. Message and data rates may apply. See our Privacy Policy.

Gutter Repair

Gutter and Downspout Repair: what it covers

Quick answer

Gutters and downspouts carry roof water to a point clear of the wall. A repair resets each run to its fall, closes the joints, clears moss and leaves from the outlets and sends each downspout's flow to ground that will take it.

Gutter and Downspout Repair illustration for Hillsboro, OR

A gutter is the outermost part of the roof and the first to be loaded by wind and debris. In a shaded yard, moss and leaves gather in the run and block the outlet, and the water spills over the low point and runs down the fascia.

The FACTS sheet records the 2020 and 2021 windstorms, which brought branches and debris down across the region, and a run torn or bent in a windstorm is a sign that the roof edge was reached. The covering above it should be checked at the same visit.

The work covered here is the reset, the sealing, the clearing and the outlet correction. Each run and each downspout is listed in the quote, so the work can be checked.

Service area
Hillsboro & Washington County
Availability
Call to reach a local roofer
Warning signs

Signs you need gutter and downspout repair

Do not lean a ladder against a gutter in wind or on wet ground. Keep clear of overhead lines near the roof edge, and use a second person on any ladder.

  • A run that holds water at one low spot instead of draining to its downspout
  • Moss or leaves packed in the outlet or the downspout elbow
  • A joint that drips at the seam between two lengths
  • A downspout with a crushed section or a disconnected elbow
  • Staining or streaks on the fascia or the wall under a run
  • Brackets pulled loose, or a run that sags between two of them
Our process

How our gutter and downspout repair visit works

  1. Measure the fall along each run

    A level or a taut line shows whether each run falls toward its outlet. Low points are marked for correction.

  2. Clear the moss and debris from the outlets

    Moss and leaves are cleared from each outlet and the downspout elbow by hand, and the outlet is flushed to confirm the flow.

  3. Reset the sagging sections

    Sagging sections are brought back to fall and re-fixed. Lengths too damaged to reset are replaced and their joints sealed with the product the maker names.

  4. Restore the downspout

    A damaged downspout is repaired or replaced, its elbow reconnected, and an extension set so the flow lands clear of the wall.

  5. Flush-test and log each run

    Each reset run is flushed with water. The log lists each run by position, the fall set, the downspout connected and the test result.

Why does moss block a gutter?

Because moss and leaves collect in the run and the outlet, hold water, and grow where the gutter stays wet, so the run blocks itself over time.

A shaded gutter stays damp, and moss grows where moisture sits. Leaves wash into the run and catch on the moss, and the outlet becomes a plug. Once water backs up, the run spills at its low point, and the wall below takes the stain.

Clearing the outlet by hand and checking the fall keeps the run working. The roofer notes the shaded runs on the record so the check is kept up.

  • Shade keeps the gutter damp
  • Moss and leaves catch at the outlet
  • Clear by hand and check the fall

What does a windstorm do to the gutter line?

It bends sections, dents the run, pulls brackets from the fascia and tears joints, and the damage shows as a sag or a leak.

Wind and debris strike the gutter line first, because it sits at the edge of the roof. A branch can dent a run, and the wind can lift a section from its brackets. The gutter's damage is a record of how hard the storm reached the edge.

After a named windstorm, the roofer records each bent or torn section with its position as part of the storm record.

  • Dents and bends at the storm-facing edge
  • Brackets pulled from the fascia
  • Joints torn at the seam

Where should the downspout send its water?

Clear of the wall, onto ground that falls away, or into a drain that carries the flow further from the foundation.

A downspout that discharges at the wall sends water back to where the building needs it least. A repair brings the outlet clear of the wall onto ground that falls away, and a splash block or a short extension is often enough.

Where the ground is flat or slopes toward the house, the flow must be carried further, priced as its own line.

  • End the outlet clear of the wall
  • Use ground that falls away
  • Carry the flow further on flat ground

What a gutter scope should list

Each run by position, the work done, the fall set, each downspout connected and a flush test after the work.

A gutter scope names each run by position, the work on it and the fall set. It states each downspout connected or replaced and ends with the flush test that shows the water now leaves.

Damage found and not repaired should be listed too, so the next contractor knows what was left as it was.

  • Runs named by position
  • The fall and the test result
  • Damage left in place, named

What a wet season does to a gutter line

It fills the runs faster than they can drain when the outlets are blocked, and it loosens brackets as the fascia swells and dries.

In a heavy wet season a gutter that is only partly clear will overflow at its low point before the rain stops. Over time the fascia behind a run swells and dries, and the brackets loosen. A run that was in fall in the summer can sag by the end of the winter.

The roofer checks the runs and the brackets before the wet season and after it. Each sag is recorded with its position, and any fascia damage behind the run is noted for the next job.

  • Overflow at the low point of a run
  • Fascia that swells and dries
  • Brackets checked before and after the season

Cleaning the gutters without damaging them

By hand, with a soft tool, from a secure ladder, and without prising the run from the fascia.

A gutter is cleaned with a soft tool and by hand, and the run is not prised from the fascia to get at debris. A pried run loosens its brackets and starts the sag the cleaning was meant to prevent.

Clean from the ladder's top rung only when the ladder is secure, and with a second person holding it.

  • Soft tool and hand clearing
  • No prising the run from the fascia
  • A second person on the ladder
Options

Types and options for gutter and downspout repair

Run reset

Restoring fall and re-fixing brackets on a run that has dropped, often enough where the metal is sound.

Outlet clearing and correction

Clearing moss and debris from the outlet, and correcting the elbow and the discharge point.

Joint and end-cap repair

Re-sealing joints and replacing end caps that have split, which stops the drip at the same spot after each rain.

Washington County

Why gutter and downspout repair is different in Portland metro

The 2020 and 2021 windstorms in the FACTS sheet are recorded as outage events, and a gutter damaged in them is a sign of the storm's reach rather than a figure for damage across the county.

Gutters under the trees in the Coast Range foothills and the shaded parts of the metro are the runs most often blocked by moss and leaves.

Gutter runs in the outlying towns are reset the same way, and the number of runs and the access set the quote.

One call and it gets handled.

Most gutter and downspout repair calls are scheduled the same day when a technician is free, and you approve the price before any work starts.

Call (833) 751-2102Get a quote
Where we work

Gutter and Downspout Repair across Washington County

Not sure if you're covered? Check your ZIP code.

Related

Moss Shade and Tree Trimming

Reducing the shade that feeds moss on roofs in Hillsboro and the towns around it, by letting sun reach the covering through careful tree trimming.

Moss Removal and Roof Cleaning

Cleaning moss and algae off roofs in Hillsboro and the Washington County towns around it, done carefully so the covering is not damaged.

Roof Leak Repair

Stopping a roof leak in Hillsboro and the towns around it: catching the drip, finding the entry point and drying the framing it has wet.

Guides

Read before you book

Trees, Shade and Roofs in Hillsboro

OSU Extension, recorded in the FACTS sheet, says shade is what makes moss thrive on these roofs, and that trimming nearby trees to let in sun is the most effective long-term fix.

FAQ

Gutter and Downspout Repair FAQs

Can I clear the gutters myself?

From a stable ladder with a second person, yes. Do not work in wind or wet weather.

Why does my gutter overflow only in heavy rain?

The outlet or downspout may be unable to carry the peak flow, or the fall may be wrong. The roofer checks both.

Is moss in the gutter a roof problem?

It can be. Moss in the run holds water that would otherwise leave, and it can lift the edge of the covering.

Does a gutter repair stop wall damage that already exists?

It stops further spill. A wall that is damp needs its source found separately.

WhatsApp